Re[4]: CA file transfer mode description.

Hmmmmmm. OK, here's a list of CMNE's for QCMN.  I'd seen references to QCASERVER
modd in CA install guide, but never quite sure if that was supposed to be 
QSERVER (typo?). I have a modd on the AS400 for QCASERVER, but NSrouter does not
use QCASERVER. Do I need to change that entry, or just add the new one?

Eric A DeLong
ericadelong@pmsc.com

------------------------------------------------------------------------------
Subsystem description:   QCMN           Status:   ACTIVE                   
                                                                           
                              Job                      Default         Max 
Device        Mode        Description    Library       User          Active
*ALL          *ANY        *USRPRF                      *SYS          *NOMAX
*ALL          QCASERVR    *USRPRF                      *NONE         *NOMAX
*ALL          QPCSUPP     *USRPRF                      *SYS          *NOMAX

______________________________ Reply Separator _________________________________
     
QSERVER needs to be started first, UNLESS you add the following entry to 
QCMN, thus preventing it from running the mode:
     
             ADDCMNE    SBSD(QCMN) DEV(*APPC) MODE(QSERVER) MAXACT(0)
     
It's the MAXACT(0) that does the trick.
     
We also use NWSAA, and you do have to be at a particular patch level to get 
it all working correctly, but the QSERVER mode still needs to run in QSERVER 
and not QCMN to work.


+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---