• Subject: Data queue's
  • From: "Jeffrey M. Carey" <jeffreycarey@xxxxxxx>
  • Date: Mon, 19 Jan 1998 13:12:03 -0600
  • Newsgroups: comp.sys.ibm.as400.misc
  • Organization: Trase Miller Solutions

We recently had a problem htat caused us to bring our 530 down with sbs
active (had a job that would not end).  When the system came up, several
dtaq were damaged.  In trying to recreate these dtaq (which had
duplicates in other libraries on the system and on our development box),
I discovered that retrieving all the needed parameters was impossible,
as was copying a dtaq (although I could save & restore, which is what I
ended up doing).

Is there a way to see all the parameters of a dtaq (e.g. TYPE *STD or
*DDM, MAXLEN, FORCE *YES or *NO, SEQ *FIFO *LIFO or *KEYED).

I did try the usrtool DSPDTAQ, but that didn't seem to show all of them.
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to "MIDRANGE-L@midrange.com".
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---


This thread ...


Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2020 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].