Re: Batch Debug

[Shylesh_Nadig@xxxxxxxxxxx]

First make sure you are submitting the job with HOLD(*YES) and then do the
following :

1. Start Service Job (STRSRVJOB) and enter the Job Name,User Name,Job
Number of the job you want to debug.

2. Start Dedub (STRDBG) and enter the program you want to debug with
UPDPROD(*YES)

3. Release your job. Message pops up asking you to press 'F10' to enter the
break point or 'ENTER' to continue.

4. Press F10 and enter break point (ADDBKP)

5. F3 to exit and continue.

Shylesh





tgrider@arkansas.net
09/25/97 01:34 PM


Please respond to MIDRANGE-L@midrange.com

To:   MIDRANGE-L@midrange.com
cc:    (bcc: Shylesh Nadig/users/IndyMac)
Subject:  Batch Debug




Sorry to ask about something that's already been answered here before,
but I'm unable to find the message I thought I had saved.  Anyway, what
are the steps to run the debugger on a program submitted to batch?
Thanks
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to "MIDRANGE-L@midrange.com".
| To unsubscribe from this list send email to MAJORDOMO@midrange.com
|    and specify 'unsubscribe MIDRANGE-L' in the body of your message.
| Questions should be directed to the list owner/operator:
david@midrange.com
+---
umidr




+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to "MIDRANGE-L@midrange.com".
| To unsubscribe from this list send email to MAJORDOMO@midrange.com
|    and specify 'unsubscribe MIDRANGE-L' in the body of your message.
| Questions should be directed to the list owner/operator: david@midrange.com
+---