Hi Midrangers!

I could not find an answer for my problem in the Work Management Manual.

A batch subsystem has MAXACT = 3
There are 3 queues:
Q1 allows one   job  at a time
Q2 allows two   jobs at a time
Q3 allows three jobs at a time
The sequence of the queues in the subsystem is Q1, Q2, Q3

The problem with this configuration is: I do not want to run three jobs from Q1 
and Q2 at a time.

Is there a possibility to configure this: "Run one job from Q1 and at most two 
jobs from Q2, but no more than two of them at a time"?

TIA,
-----------------------------------------------------------------
Dipl.-Ing. Rudolf Wiesmayr   Tel:     +43 - 0732 / 7070 - 1720
Magistrat Linz, ADV/AE       Fax:     +43 - 0732 / 7070 - 1555
Gruberstrasse 40-42          mailto://Rudolf.Wiesmayr@mag.linz.at
A-4041 Linz                  IBMMAIL: at3vs7vs@ibmmail.com
------ http://www.linz.at <<<--- Digital City Linz, Austria -----
- City of Linz: awarded by 'Speyerer Qualitaetswettbewerb 1996' -

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to "MIDRANGE-L@midrange.com".
| To unsubscribe from this list send email to MAJORDOMO@midrange.com
|    and specify 'unsubscribe MIDRANGE-L' in the body of your message.
| Questions should be directed to the list owner/operator: david@midrange.com
+---


This thread ...

Follow-Ups:

Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2019 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].