Re: Debugging ILE program in Batch

[Gordon.Searles@xxxxxxx (Gordon Searles)]

Michael A. Franchino wrote:
> 
> One of my co-workers is trying to debug an ILE RPG program that runs in
> batch. What is the trick to get this to work? He started STRSRVJOB on the
> job then tried to STRDBG on the program. The message said that the service
> job is not active an would not let him place a breakpoint.
> 

Michael,

Here is the sequence I have used successfully to start a service job.
1. Hold JOBQ that job will be submitted to, or SBMJOB HOLD(*YES).
2. STRSRVJOB on the job while it is held.
3. STRDBG on program of choice.
4. Release job.
5. The system will present you with the "Start Serviced Job" display.
   From here you can press F10 to get a command line and be able to add
breakpoints.

One last thing I should point out is that if the job is active then you
will be able to add breakpoints right after you start debug.  You will
not get the "Start Serviced Job" display.

Hope this helps.

-- 
Gordon Searles
Senior Systems Programmer
Recreational Equipment, Inc. (REI)
Quality Outdoor Gear and Clothing Since 1938
http://www.rei.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* This is the Midrange System Mailing List!  To submit a new message,   *
* send your mail to "MIDRANGE-L@midrange.com".  To unsubscribe from     *
* this list send email to MAJORDOMO@midrange.com and specify            *
* 'unsubscribe MIDRANGE-L' in the body of your message.  Questions      *
* should be directed to the list owner / operator: david@midrange.com   *
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *