Re: Help on recovery

Sanjeev Gopal wrote:
> 
> Hi,
> 
> We work on remote AS/400s through international satellite links. There
> are frequent cases of link failure (3 to 4 times a day), and in those
> cases, we lose all unsaved work. We are not able to get back to where we
> were when the link comes up again. This is true even in the case of a
> power failure in any of the local workstations. 
<<SNIP>>
> Is there any way of getting over this problem. I strongly feel that we
> have overlooked certain factors when setting up the link as well as the
> remote AS/400.
> 
> We look forward to an early and positive reply.
> 
> Thanks,
> 
> Sanjeev Gopal
> DSQ Software Limited
> Madras, INDIA.

Try setting the System Value QDEVRCYACN to *DSCMSG.  If it is currently
at *ENDJOB or *ENDJOBNOLIST everytime there is a device error on the
device (ie when the link drops), your session will be signed off.  With
the value changed to *DSCMSG, your session will be disconnected.  To
reconnect, all you need to do is sign back on at the SAME workstation
with the SAME userid, and your session will be as you left it. 

 You might also want to make sure that the value of QDSCJOBITV is set
to  a value other than *NONE (perhaps 120 minutes), so if you don't sign
back after 2 hours the job is ended.

HTH

Pete Massiello
OS Solutions International
Voice (203)-744-7854  Ext 11
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* This is the Midrange System Mailing List!  To submit a new message,   *
* send your mail to "MIDRANGE-L@midrange.com".  To unsubscribe from     *
* this list send email to MAJORDOMO@midrange.com and specify            *
* 'unsubscribe MIDRANGE-L' in the body of your message.  Questions      *
* should be directed to the list owner / operator: david@midrange.com   *
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *