remote connections

Greetings,

We are attempting to connect some of our remote locations to our main   
site using Cisco routers and 5394 remote workstation controllers.  The   
 routers and leased line will also be handling traffic from our   
token-ring LAN.

The sequence is:
AS/400 --> router --> CSU/DSU --> 56K leased line --> CSU/DSU --> router   
 -->  5394 --> terminals

We can get communication from the AS/400 as far as the remote router, but   
the controller and devices remain 'vary on pending' so our assumption at   
this point is that it is a configuration problem of some kind.

Is there anyone who has had some experience in setting up a scenario like   
this?
 Any special 'gotchas' to watch out for in the configuration of the   
router or the 5394, or in the configurations on the 400?
   

TIA

 -doug


**********************************
Doug Johnson
System Administrator
The University Book Store
711 State Street
Madison, WI   53703

phone: 608-257-3784
fax: 608-257-9479
email: djohnson@univbkstr.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* This is the Midrange System Mailing List!  To submit a new message,   *
* send your mail to "MIDRANGE-L@midrange.com".  To unsubscribe from     *
* this list send email to MAJORDOMO@midrange.com and specify            *
* 'unsubscribe MIDRANGE-L' in the body of your message.  Questions      *
* should be directed to the list owner / operator: david@midrange.com   *
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *