×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
Kevin,
My previous experience points me upto Rel 6 only so I have no idea how a MRP run will perform after that level help but I have few questions:
a) Do you run 2 full MPR executions?
b) Do you run them under a "dedicated mode"?
c) Have you tested running a MRP FULL Run and then an MRP NET run to see how much it takes?
On Rel 6, MRP NET Run was very slow so we were running MRP Full runs only ... and we also had a similar scenario compared to yours in terms of no program modifications during the imp0lementation of this, we do clear and set up few critical files, etc...
Peter Vidal
-----Original Message-----
From: mapics-l-bounces@xxxxxxxxxxxx [mailto:mapics-l-bounces@xxxxxxxxxxxx] On Behalf Of Kevin Fish
Sent: Wednesday, September 12, 2012 5:30 PM
To: MAPICS-L@xxxxxxxxxxxx
Subject: [MAPICS-L] MRP run time
I have a question regarding MRP run time. We've installed ISL and CFL which requires running MRP twice for some warehouses. The total MRP/MPSP run was taking about 4 ½ hours. Suddenly it jumped an additional two hours. There's no new data or program changes, we clear recommendations from PLNORD, ORDREV, and REQMTS before each run, we turned off the reports. Short of turning on another processor, what other suggestions are out there to make MRP/MPSP run faster? We are on 7.8.
_______________________________________________
This is the MAPICS ERP System Discussion (MAPICS-L) mailing list To post a message email: MAPICS-L@xxxxxxxxxxxx To subscribe, unsubscribe, or change list options,
visit:
http://lists.midrange.com/mailman/listinfo/mapics-l
or email: MAPICS-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives at
http://archive.midrange.com/mapics-l.
midrange.com
