Try 10zig...the old bosanova folks...have a great controller that plugs
right into Ethernet and lets your twinax stuff plug into it... If I were
still writing my column it would get very high marks!
-----Original Message-----
From: mapics-l-bounces@xxxxxxxxxxxx [mailto:mapics-l-bounces@xxxxxxxxxxxx]
On Behalf Of Otto Meyn
Sent: Tuesday, June 28, 2011 3:54 PM
To: MAPICS ERP System Discussion
Subject: Re: [MAPICS-L] New ISeries - Old Twinax
check with systemID
________________________________
From: mapics-l-bounces@xxxxxxxxxxxx on behalf of LeLeux, James
Sent: Tue 6/28/2011 3:30 PM
To: MAPICS ERP System Discussion
Subject: [MAPICS-L] New ISeries - Old Twinax
As I started to write this, I couldn't remember how to spell twinax! That's
when you know it's old!
All,
We are obtaining a new ISeries and we have a couple of great hi-speed twinax
printers we'd like to retain.
Can anyone recommend some devices that go from TCP/IP to twinax?
I've done the opposite with lasers.
Thanks so much for any input!
James LeLeux
IT Director: Cherry, Shur-Lok, & SPS Santa Ana
2701 South Harbor Blvd
Santa Ana, CA 92704
M 714-929-8063
SKYPE james.leleux
jleleux@xxxxxxxxxxx
_______________________________________________
This is the MAPICS ERP System Discussion (MAPICS-L) mailing list
To post a message email: MAPICS-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit:
http://lists.midrange.com/mailman/listinfo/mapics-l
or email: MAPICS-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at
http://archive.midrange.com/mapics-l.
midrange.com
