R6 Integrator question

We are at Release 6. I need to be able to build a part description
based on the attributes of the part, using a series of drop down
selection boxes. For example, from drop down box 1 "gear motor" is
selected, then drop down box 2 displays for a selection of applicable
horsepowers, then drop down box 3 displays for a selection of applicable
gear ratios, then drop down box 4 displays for a selection of applicable
bore sizes. From these selections, I would generate a part description
of "GMTR,.25HP,8.2:1,20MM" to accurately describe this part - a .25
horsepower gear motor with a 8.2:1 gear ratio and a 20mm bore.



Is there a way to do this within Integrator? If so, how might I best
accomplish this? My knowledge of Integrator is somewhat limited, so the
more detail you can provide, the better.



Thanks...






*** Please note ***

The information contained in this email message and any attached files is confidential information. If you are not the intended recipient, you should not read, copy, use, or disclose them in any manner, electronic or otherwise, without authorization.

If you have received this email in error, please notify us immediately by reply email to sender and delete all copies.

It is your responsibility to scan this communication and any files attached for computer viruses and other defects.

Hartness International, Inc. its affiliates, and related entities ("Hartness") do not warrant, represent, or guarantee the accuracy or completeness of any information contained in this email or attached files. Hartness does not accept liability for any loss or damage (whether direct, indirect, consequential or economic) however caused, and whether directly or indirectly from this email or any attached files.
*-*-*-*-*-*-*-*