Re: How to debug AMM63?

To: mapics-l@xxxxxxxxxxxx> From: Peter_Vidal@xxxxxxxx> Date: Mon, 4 Feb 2008 16:10:22 -0500> Subject: Re: [MAPICS-L] How to debug AMM63?> > Dave:> > Thank you for your help. This job I am debugging is part of MRP and goes > to the job queue, so I followed these steps:> > a) Compiled with CRTBNDRPG with DBGVIEW = *ALL> b) Make sure the program is highest in the MAPICS library list.> c) Place the job queue where the job will naturally go and held it. (ie. > QBATCH1) > d) Went into MAPICS and submitted the job.> e) Back to my QBATCH1, I placed on hold my job and the released the job > queue.> f) Get the job name, user id and job number and then used STRSRVJOB on it.> f) Do STRDBG in the servicing job.> g) Release the job queue.> > ==Immediately I had the message:> ==Start Serviced Job > ==Job: AMN8877165 User: PVIDAL Number: 860059 > ==The serviced job has been released from the job queue. Press Enter to > ==start the job or F10 to enter debug commands for that job. > > Probably I will try Websphere the next time around.> > Thank you very much Dave!> > > Peter Vidal> MAPICS IT TECHNICAL SUPPORT TEAM / SR SYSTEM ANALYST> 10540 Ridge Rd., Suite 203, New Port Richey, FL 34654-5111> Tel:727-849-9999, x2414 Fax:727-815-3120> WWW.PALL.COM> > "Aim for success, not perfection. Never give up your right to be wrong, > because then you will lose the ability to learn new things and move > forward with your life."> Dr. David M. Burns> > --------------------------------------------------------------------------------> > Attention:> > This communication may contain information that is confidential,> privileged and/or exempt from disclosure under applicable law. > If you are not the intended recipient, please notify the sender > immediately and delete the original, all attachments, and all > copies of this communication.> > > --------------------------------------------------------------------------------