Re: Creating Mfg. orders programatically

I have done so at R6 (and previous releases).  Both by creating batches or
by updating the files immediately (including Material records, and yes ,
this is the hardest part in it).  I do not support blow-thru however (at
this time, nor UNcontrolled floor stock).  Both procedures live happily side
by side. and have been working for years now (very stable).

Kris De Vlieger


----- Original Message ----- 
From: "David Hayes" <DHayes@xxxxxxxxxxxx>
To: <MAPICS-L@xxxxxxxxxxxx>
Sent: Wednesday, January 31, 2007 5:03 PM
Subject: [MAPICS-L] Creating Mfg. orders programatically

Has anyone else had the need to create manufacturing orders outside of
MAPICS (since there doesn't seem to be an off-line load within R6
MAPICS)?  How did you go about it?  All I need are MOMAST and MOROUT
recs.




*** Please note ***

The information contained in this email message and any attached files is

confidential information.  If you are not the intended recipient, you should
not read, copy, use, or disclose them in any manner, electronic or
otherwise, without authorization.

If you have received this email in error, please notify us immediately by

reply email to sender and delete all copies.

It is your responsibility to scan this communication and any files

attached for computer viruses and other defects.

Hartness International, Inc. its affiliates, and related entities

("Hartness") do not warrant, represent, or guarantee the accuracy or
completeness of any information contained in this email or attached files.
Hartness does not accept liability for any loss or damage (whether direct,
indirect, consequential or economic) however caused, and whether directly or
indirectly from this email or any attached files.

_______________________________________________
This is the MAPICS ERP System Discussion (MAPICS-L) mailing list
To post a message email: MAPICS-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/mapics-l
or email: MAPICS-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/mapics-l.