Re: Fully indented costed BOM

["aldg" <aldg@xxxxxxxxxxxx>]

Hi George Sagen:

AMEG71, "Single Level Cost Sheet - Current [or Stanard]" is not an indented BOM 
type of report.  You should be trying to get AMEG72, "Indented Cost Sheet - 
Current [or Standard]" which should display the entire product structure from 
the end item product down thru manufactured components to raw materials and 
purchased components.

Regards....

------Your 6/7/01 Original Mapics ML Message------

>From: GeoMSagen@aol.com
>Reply-To: MAPICS-L@midrange.com
>Date: Thu, 7 Jun 2001 17:01:35 EDT

>I'm on V4 and looking for a FULLY indented costed bill of materials. The one 
>I'm printing isn't going deep enough to get to the raw materials in all cases 
>(AMEG71). What's the rational for the level at which it chooses to stop?
>
>Thanks in advance.
>
>George Sagen
>
------End of Your Original Mapics ML Message------


--
Above message before copy enclosure (if any) was sent by:

Al Gershen
Grants Pass, OR 97526 
aldg@mail.rvi.net; aldg@webtv.net;
ICQ # 12342782; and thru 
MSN Messenger (aldg@hotmail.com)

--
+---
| This is the MAPICS Mailing List!
| To submit a new message, send your mail to MAPICS-L@midrange.com.
| To subscribe to this list send email to MAPICS-L-SUB@midrange.com.
| To unsubscribe from this list send email to MAPICS-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: 
|daveshaw@bellsouth.net
+---