Code 400 and IBM Distributed Debugger Problems

["Weber, Richard" <Weberr@xxxxxxxxxxx>]

There are a few of us in our shop testing this out before rolling it out.
We are using Version 4 and have noticed a few problems, besides slow access
times.

1.      When we start the debugger and attempt to bring up the job list from
our host from the attach panel, we receive the message "Logon Failed, Check
Userid and password and try again", and yes, we have been real careful to
type them correctly.  More than one of us has tried.  When we log straight
on to the AS/400 it tells us that there was a failed logon attempt. 

2.      When two of us are using Code 400, and the first person who loaded
Code 400 attempts a compile, the second person to load it gets the compile
completion message and the message listing panel.  

3.      When compiling in COBOL and we receive an error message listing, it
is impossible to link from the message panel to the edit session because the
line numbers don't match up.  We know this happens because of extra lines
included for the copybooks and externally described objects at compile time
cause the line numbers to increment higher than the actual number of lines
in the source member.  Is there any solution for this?


                Regards.

                    Richard L. Weber 
                         TOYS 'Я' US 
                MIS - International Division
                  * (201) 802-5744
            Fax (201) 802-5799



======================================================================== 
This email message is for the sole use of the intended recipient (s) and may
contain confidential and privileged information. Any unauthorized review,
use, disclosure or distribution is prohibited. If you are not the intended
recipient, please contact the sender by reply email and destroy all copies
of the original message. To reply to our email administrator directly, send
an email to EmailAdmin@xxxxxxxxxxxx 
Toys "R" Us, Inc.