Re: Problem Initiating The Debuger From Code 400

Mike,

Could you please try the following steps?
.  Bring up a DOS prompt and use command "echo %USERPROFILE%" to see the
directory where USERPROFILE set to.
.  Go to that directory, and from there, go to dbgProf directory.  List all
the files with extension .cfg to see if there is one called CLIPPER.cfg.
If there is, please delete   it and try again.  If not, please give me a
list of the files with extension .cfg.


Regards,

Xuan Chen, Debug for iSeries
(905) 413-3769 T/L 969-3769
xuanchen@ca.ibm.com




                                                                                
                                                        
                      Mike Kardas                                               
                                                        
                      <MKardas@clippergro        To:       
"'code400-l@midrange.com'" <code400-l@midrange.com>                          
                      up.com>                    cc:                            
                                                        
                      Sent by:                   Subject:  Problem Initiating 
The Debuger From Code 400                                 
                      code400-l-bounces@m                                       
                                                        
                      idrange.com                                               
                                                        
                                                                                
                                                        
                                                                                
                                                        
                      01/24/2003 05:00 PM                                       
                                                        
                      Please respond to                                         
                                                        
                      CODE/400 Discussion                                       
                                                        
                      & Support                                                 
                                                        
                                                                                
                                                        
                                                                                
                                                        



When I initiate the Debugger from Code 400 it ask me to log on my debugger
host.  The host name is not correct on the logon box and therefore I cannot
log into the host.  How do I change the host name on the logon box?

Sincerely

Mike Kardas
Clipper IT Department
Phone (630) 739-0700 x 212
Fax   (630) 739-0358
E-Mail MKardas@Clippergroup.com


_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L@midrange.com
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo.cgi/code400-l
or email: CODE400-L-request@midrange.com
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.

NOTE: WDSc for iSeries disucssion has it's own mailing list.
Information can be found at
http://lists.midrange.com/cgi-bin/listinfo/wdsc-l