RE: Network connection

[David Wright <dwright@xxxxxxxxxxx>]

If you check your job log, you may see that your Communications Daemon has
already made the strcode connection for you...

I have not been able to use the Debugger through VPN, but everything else is
fine....

hth,
Dave

-----Original Message-----
From: Reeve Fritchman [mailto:reeve@ltl400.com]
Sent: Wednesday, November 21, 2001 11:21 AM
To: CODE400-L@midrange. com
Subject: Network connection


I'm having trouble starting a CODE/400 server when working through my
network connection.

I have two systems connected to a Netgear RT314 Gateway Router (no ROTFLYAO,
please) and then into a cable modem up to the 820 via a firewall.  The RT314
provides NAT and some firewall protection.  The IP address seen by the RT314
is not fixed (today it's 65.34.yada.yada); within the LAN, the RT314 is
192.168.0.1 and the other systems are ".2" and ".3".

When I use a dial-up connection (without the RT314), everything works fine
(because CODE/400 knows my IP address).  I think this shows the server end
is not causing the problem.

I assume the RT314 is the issue.  The iBox is giving me EVF4000, "A remote
host refused an attempted connect operation."  (3425).

I'd be grateful for any help...

Thanks,
Reeve

_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L@midrange.com
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/cgi-bin/listinfo/code400-l
or email: CODE400-L-request@midrange.com
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.