RE: Put to Host

["Phil" <sublime78ska@xxxxxxxxx>]

Volaine,

The version I'm using is V4R5M1 SP2.

If I happen to have the member open in a 5250 screen and forget about it,
and do a put to host, what I **don't** get is the PUT OK message.  The only
message I get is >exit.

The annoying part is that it doesn't stop uploading when the member is
locked, which can be a long time (I always connect remotely, which is why I
don't use the STRCODE stuff).  I've cancelled in the past but that usually
ends up with the server being "in use" until I end the app in task mgr and
call the /cm exit pgm.  So I let it continue.

Like I said, I'm slowly learning to check these things before I upload.

But it would be nice for Code to tell me it **can't** PUT successfully
before uploading the file rather than **not** telling me the PUT was ok
after uploading the file.

Phil



> -----Original Message-----
> From: code400-l-admin@midrange.com
> [mailto:code400-l-admin@midrange.com]On Behalf Of batthish@ca.ibm.com
> Sent: Monday, September 24, 2001 9:30 AM
> To: code400-l@midrange.com
> Subject: RE: Put to Host
>
>
> Phil,
>
> You don't mention what version + service level you are at, but when I try
> using V5R1M0 Service Pack 2 I do get an error.
>
> When the member is not locked,  I see the following:
> D:\temp\>codesrv put OS400 proof.irp
> PUT OK: proof.irp --> BATTHISH/QRPGLESRC(PROOF)
>
> PUT OK indicates that the PUT was successful.
>
>
> When I try and the member is locked, I get the following:
> D:\temp\>codesrv put OS400 proof.irp
> Member locked in object .
>
> I think that the message is explanatory enough.
>
> Thanks,
> Violaine Batthish
> CODE Project Lead
> batthish@ca.ibm.com          IBMCA(BATTHISH)
>
> WDT/400 page:  http://www.ibm.com/software/ad/wdt400
> WDT/400 Support : http://www.ibm.com/software/ad/wdt400/support
>
>
>
>


_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com