RE: Put to Host

[batthish@xxxxxxxxxx]

Phil,

You don't mention what version + service level you are at, but when I try
using V5R1M0 Service Pack 2 I do get an error.

When the member is not locked,  I see the following:
D:\temp\>codesrv put OS400 proof.irp
PUT OK: proof.irp --> BATTHISH/QRPGLESRC(PROOF)

PUT OK indicates that the PUT was successful.


When I try and the member is locked, I get the following:
D:\temp\>codesrv put OS400 proof.irp
Member locked in object .

I think that the message is explanatory enough.

Thanks,
Violaine Batthish
CODE Project Lead
batthish@ca.ibm.com          IBMCA(BATTHISH)

WDT/400 page:  http://www.ibm.com/software/ad/wdt400
WDT/400 Support : http://www.ibm.com/software/ad/wdt400/support




                    "Phil"
                    <sublime78ska@yaho       To:     <code400-l@midrange.com>
                    o.com>                   cc:
                    Sent by:                 Subject:     RE: Put to Host
                    code400-l-admin@mi
                    drange.com


                    09/21/2001 05:07
                    PM
                    Please respond to
                    code400-l





I'm only uploading the member.  I'm not connected while editing.

Every once in awhile I'll have a 5250 session up with the member open and
forget about it, click to upload the member and then realize what I did.  I
know better than to cancel the upload so I let it finish and then do it
again.

I'm slowly learning to make sure I don't have the member open before
uploading.

Phil

> -----Original Message-----
> From: code400-l-admin@midrange.com
> [mailto:code400-l-admin@midrange.com]On Behalf Of darren@dekko.com
> Sent: Friday, September 21, 2001 4:47 PM
> To: code400-l@midrange.com
> Subject: Re: Put to Host
>
>
>
> How are you getting the member open twice?  When I open the member in
CODE
> first I can't open it in SEU because its locked.  When I open it in SEU
> first it opens into CODE as a read-only file.
>
>
> _______________________________________________
> This is the CODE/400 Discussion & Support (CODE400-L) mailing list
> To post a message email: CODE400-L@midrange.com
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/cgi-bin/listinfo/code400-l
> or email: CODE400-L-request@midrange.com
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/code400-l.
>


_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com

_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L@midrange.com
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/cgi-bin/listinfo/code400-l
or email: CODE400-L-request@midrange.com
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.