Re: V4.5 SP1 -- Out of Disk Space

[batthish@xxxxxxxxxx]

Hi Bill,

For myself, I found that temporarily changing both the TEMP and TMP
environment variables worked.  However, I can note that I still had
problems due to the fact that I had forgotten to run the service pack
install from the DOS session where I had changed the environment variables
:)

thanks,
Violaine Batthish
CODE/400 Project Lead
batthish@ca.ibm.com          IBMCA(BATTHISH)

CODE/400 page:  http://www.ibm.com/software/ad/varpg
CODE/400 Support : http://www.ibm.com/software/ad/varpg/support



"Bill" <bubbzbill@yahoo.com>@midrange.com on 01/29/2001 05:41:59 PM

Please respond to CODE400-L@midrange.com

Sent by:  owner-code400-l@midrange.com


To:   <CODE400-L@midrange.com>
cc:
Subject:  Re: V4.5 SP1 -- Out of Disk Space


Both the tmp and temp variables are pointing to the big drive.  Moving
stuff off the c drive would be a bit painful, and of course shouldn't be
necessary (it'll be the last resort I guess).
 ----- Original Message -----
 From: David Wright
 To: CODE400-L@midrange.com
 Sent: Monday, January 29, 2001 12:57 PM
 Subject: RE: V4.5 SP1 -- Out of Disk Space

 The problem may lie with where your TEMP files are being stored...

 I am pretty sure that if you change your TMP & TEMP environment variables
 to a different drive before starting, you will be able to complete the
 install...

 Or, it might be easier to just move some data off of the C drive long
 enough to do the install...  Then move them back when the install
 completes.....




+---
| This is the CODE/400 Mailing List!
| To submit a new message, send your mail to CODE400-L@midrange.com.
| To subscribe to this list send email to CODE400-L-SUB@midrange.com.
| To unsubscribe from this list send email to CODE400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: larry@paque.net
+---