Re: Power 8 Installation Issue

Yeah, I'm with you on the PTF idea. The IOA comes up fine in service tools;
it reports as operational.

I haven't found anything so far that suggests the card and tape aren't
supported, other than the reference that said it could not be used for an
ALT-IPL.

Reports as a 57B4 in the HMC, basically a EJ0J which tells me it needs LIC
of at least TR7 with MF57865, MF57923, MF58006 all of which appear to be in
TR10 - which is the LIC DVD I am using.

Pre-requisites for EJ0J
https://www-912.ibm.com/e_dir/eserverv7prereq.nsf/HW2/Hardware~eServer~EJ0J~378003673D8750DB86257A910052106D?OpenDocument

Interestingly if I go the System Storage Interoperation Center the adapter
it tells me I need for the library is a 5912

https://www-304.ibm.com/systems/support/storage/ssic/interoperability.wss


On Wed, Jul 15, 2015 at 10:22 AM, Bryan Dietz <bdietz400@xxxxxxxxx> wrote:

My first guess is that you are "missing" PTF's that support either the
device or the IOA card.

if you go into service tools to look at the hardware resources what is the
status?

Bryan


Evan Harris wrote on 7/14/2015 4:48 PM:

Hi guys

I am currently doing a build of a new test system for a customer and
having
a few hiccups along the way.

The machine I am using is a new Power 8 S824 6. It has a TS2900 tape
library with HH LTO6 attached to a 57B4 SAS adapter. It is intended to run
the IBM i Operating system (no VIOS)

The problems I am having are around getting the tape drive visible. It is
not supported as an ALT-IPL device as far as I can tell from the IBM docs.

That's OK, I half expected that and have a V7R1 DVD to boot from which
according to me is resave level RS-710-N so V7R1 TR10. Despite that I
can't
seem to get the tape library visible as an alternate installation device
either after booting from DVD.

The library is currently set to sequential mode as an autoloader.

I have an option 21 save from the customer test system and at this point
what I am thinking about doing is installing LIC form the DVD and then
installing Base OS from DVD as well. After that I will do the rest of the
recovery from Tape and then go back and reload/re-apply all the PTFs.

Anybody got any other suggestions as to what I missed or what I can try ?

If the config is not quite supported that's OK, I'd just like to know
that;s the case (haven't been able to track down a definitive IBM doc as
yet) - I didn't do the config I just got sent out to make it work....

--

This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.