The CEC 5901 disk controller will make it worse. Back when 1st built this LPAR, it was long and slow.
If I had an extra disk slot, I would include hot spare.
Here are some times IBM sent me a while back.
I'm thinking 6 to 12 hours.
Description Values Values Values
Disk Drive CCIN 58B4 19B3 19A3
IOA CCIN 57B5 57B5 57B3
RAID Type 5 5 5
DPH devices? n n n
# of Drives per IOA 18 24 8
Process Time (hrs)
Initialize load source 1 14 14
Start RAID (no drives config'd) 1 11 11 Add to ASP 1 2 2
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of DrFranken
Sent: Sunday, March 16, 2014 10:52 PM
To: Midrange Systems Technical Discussion
Subject: Re: 8205 Disk Drive errors 19A3FFF9 - Drive type 19A3
Well as a 10K RPM disk it should take 50% longer to fail than a 15K
RPM Disk, right? :-)
Just a suggestion that Hot Spare would be a great idea with these vary large and somewhat slower disks. I'm going to peg rebuild time on a drive that size at 6 Hours or more from the time IBM physically replaces the disk unit.
- Larry "DrFranken" Bolhuis
On 3/16/2014 10:15 PM, Steinmetz, Paul wrote:
One of my disk drives on my software test partition called home.--
Drive type 19A3 571GB 10k RPM, 120+ temp failures , beginning at 6:15 this morning.
Drive is being replaced tomorrow morning, Raid5 protection.
This is our 1st disk failure on our Power7, installed 3/2012 _____
Paul Steinmetz IBM i Systems Administrator
Pencor Services, Inc.
462 Delaware Ave
Palmerton Pa 18071
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list To post a message email: MIDRANGE-L@xxxxxxxxxxxx To subscribe,
unsubscribe, or change list options,
or email: MIDRANGE-L-request@xxxxxxxxxxxx Before posting, please take a moment to review the archives at http://archive.midrange.com/midrange-l.
This mailing list archive is Copyright 1997-2015 by MIDRANGE dot COM and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available here. If you have questions about this, please contact