Can you go into IVM and use Operator Panel Functions there to do the 65, 21, 21? I know you can do this with HMC but I think that's also available on IVM.

- Larry "DrFranken" Bolhuis

On 1/14/2013 7:05 PM, Pete Helgren wrote:

Unfortunately this is a JS-12 blade that only has a "Remote Control
Panel" which is a virtual representation of what a physical panel would
look like. BUT, the Ops Console (LAN Connected) will not display the
remote control panel for some reason hence I cannot change the settings
(or I would)!

Might have to do an "ugly bounce" on this one......

Pete Helgren
GIAC Secure Software Programmer-Java

On 1/14/2013 5:50 PM, Kirk Goins wrote:
You might be able to 'Reset' the Console via the Control Panel. using
25, 26, 65 and 21

Try Googling iSeries Console Reset 65 21

All you wnat to do is disable and the enable the console

On Mon, Jan 14, 2013 at 3:01 PM, Pete Helgren <pete@xxxxxxxxxx> wrote:

Subject says it all. IBM i 6.1. I varied off the Ethernet line to make
some configuration changes and intended to connect using the Operations
console (should have done it the other way around I guess). Ops console
prompted me for Service tools user ID and password and console only
displays a screen with the following highlighted at the bottom:

Console recovery / take over is currently turned off.

Remote Control Panel does not display so I am not exactly sure how to
proceed. I could force an IPL the hard way but if there is a graceful
way to recover, I'd love to hear it.

Pete Helgren
GIAC Secure Software Programmer-Java

This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives

This thread ...


Return to Archive home page | Return to MIDRANGE.COM home page