The only relationship I have noticed between Netserver and QNTC is in the Netserver setup you specify what domain to broadcast shares to.
I find this correlates to what will just show up when you do a 5 on QNTC.

I find that if I am trying to connect to a system outside of that specified domain things work better if I use the IP address of the target system when doing a MKDIR.
I also sometimes have to create a local user on the target system with the same profile and password as the windows domain user and it will start working.

In my experience the most common problems are actually the windows authority.
Check authority on the share AND the windows folder you are sharing, make sure 'everyone' has read access.
When you get it working you can try removing authority until it stops working.
make sure your windows password is lower case

Please only print this email if really necessary
Technical Resource

55, rue Adrastée - Parc Altais F-74650 1, Phoenix Mill Lane - Suite 203 -
CHAVANOD Peterborough NH 03458 - USA
Tel. +33 (0)4 50 57 83 96 Tel. + 1 603 371 9074 ext 505
Cell. +33 (0)6 11 15 69 59 Toll. free +1 800 676 4709 ext 505

***This e-mail and its attached documents are confidential and intended solely for the use of the addressee(s). ARCAD Software can in no way be held responsible for any damage resulting from an incident involving security, integrity, virus or transmission delay. As the integrity of this message cannot be guaranteed on Internet, the ARCAD Software company cannot be held responsible for its contents. Any unauthorized use or dissemination is prohibited.***

This thread ...


Return to Archive home page | Return to MIDRANGE.COM home page