Re: Remote 5250 Console Connection

This is not optimal! Clearly the 'Current state of console tag' being 0
is bad. You definitely want that to be 4 for HMC. I believe if you set
option 4 and press ENTER it will set the console tag to 4. Since V5R3 a
tag value of 0 may cause 'no console' issues and this may be what you're
seeing.

- Larry "DrFranken" Bolhuis.


On 6/24/2010 4:04 PM, Dave Snyder wrote:

This is what SST shows. Not exactly sure what all the settings mean.

Select Console
System:

Allow console recovery and console can be taken
over by another console . . . . . . . . . 2 1=Yes, 2=No

Select one of the following:
Console type . . . . . . . . . . . . . . . . 4
1. Twinaxial
2. Operations console(Direct)
3. Operations console(LAN)
4. Hardware management console(HMC)
Current state of console tag . . . . . . . . 0


Allow supported internal LAN adapter to
be the console . . . . . . . . . . . . . . . 1 1=Yes, 2=No
Allow supported Gigabit LAN adapter to
be the console . . . . . . . . . . . . . . . 1 1=Yes, 2=No


Device is on controller CTL01.

Dave Snyder

--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.