Re: Need some assistance setting up operations console on 9406-600

[Vernon Hamberg <vhamberg@xxxxxxxxxxx>]

You have to do some kind of DST change to make the console type 
different. It ought to be in the book somewhere.
 Or at InfoCenter.

At 02:43 PM 2/6/2007, you wrote:

> Hi all,
>
> I'm the proud owner of a 9406-600 that is currently set up to use Twinax as
> its console session.  I would like to change that to Operations 
> Console.  I have
> followed all the directions in the V5R1 manuals and set up the 
> software properly
> on the PC, it just cannot see the AS/400.  I have set the QAUTOCFG 
> value during
> IPL, and it still defaults to twinax no matter what comms port I 
> use.  Now, I have
> 2 cards in the system with WAN ports on them, but I'm not sure which 
> one I should
> be using for the operations console session.  The diagrams in the 
> Operations Console
> setup manual show a model 600 with only the dual WAN port card, 
> which I have, but
> above it in the second slot (I think) from the top, there is the 
> twinax/WAN card,
> which is used as the console at the moment.  if necessary I can pull 
> the twinax
> card.
>
> What should I do to get this working?  Nothing I change on the /400 
> side seems to
> help.
>
> Thanks
>
> Julian
>
> --
> This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
> To post a message email: MIDRANGE-L@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/midrange-l
> or email: MIDRANGE-L-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/midrange-l.