I remember in earlier releases (not sure if V4R5) but
a live ethernet cable must be plugged in for the ethernet card to vary on.
Also, tcp ip must be started. In the last ipl should have msgs if tcp ip
started successfully.
jim
----- Original Message -----
From: <midrange@xxxxxxxxxxxxxxxx>
To: <midrange-l@xxxxxxxxxxxx>
Sent: Sunday, November 26, 2006 10:07 AM
Subject: net work configuration problem V4R5MO
Hi List
I am having trouble configuring a network interface on V4R5MO, can any one
advise?
This is the sequence of events I have followed so far:-
*fresh install V4R5MO
*CRTLINETH *(on top of defaults)
Line descriptor ETHLINE
Resource name CMN04
Enable for TCP/IP *yes
Autocreate controller *yes
I try to start (change status) and I have error:-
'Line ETHLINE vary on failed'
The resource looks okay as this command shows:-
*WRKHDWRSC
CMD04 type 2838 Operational Ethernet Port
Then I use CFGTCP add an interface with our network settings then try to
start, it fails to start. I have not got round to adding default route or
starting the TCP subsystem yet (STRTCP) until this is fixed.
Any advise would be greatly appreciated.
Thanks, Damian Brasher RHCE
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.
