|
1. I would narrow the line length. Often if I don't double check the editor's settings when I print the lines wrap and make it difficult to read. Perhaps lines not longer than 70 char. To allow for print margins. 2. This may not be doable, but fill in the bus numbers for each chassis (currently only shows "BUS#"). And have the chassis number as shown on the hardware display panel on the report with the chassis model number. 3. Maybe on stacked chassis (ie 5294) list the top before the bottom. It seems more logical to read top down. 4. I get shown the load source drive from iSeries Nav. But that is after the system is installed and OS loaded. Could this partition drive 'slot' that will hold the Load Src drive be flagged? 5. In the processor and memory section show unallocated/unused amounts. --- Doug Hart
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.