I'm running out of ideas...
We have a Lexmark Optra SE3455 that until last week was attached via
twinax. We moved the printer to a location where another printer (an HP4,
I believe) had been hooked up on a HP JetDirect network box. I have it set
up as a remote writer. It prints just about anything that I throw at it
from the AS/400 but the users are complaining that the font is smaller now
than it used to be. I've seen before and after examples and they are
correct. It's not a huge difference but it makes the margins almost a
half-inch wider. I have tried different emulations but no difference. I
started it as a HP6. I'm open to suggestions.
Dave Parnin
Nishikawa Standard Company
Topeka, IN 46571
daparnin@xxxxxxxxxxxxxxxxxx
