|
I had a Smart-UPS on my AS/400 until very recently. (We moved the 400 to another data center.) Ordering the signal cable was no problem. The power plugs were a pain. I ended adding two power distribution units to accomodate them. Once we had it installed, it worked great. If the power went out for real, the system got the message and shut itself down if necessary. On the other hand, every tiny blip seemed to set off the UPS. Almost daily, it would go on and off battery in the space of a few seconds, which would send the warning messages to QSYSOPR. Fortunately, this did not cause a shutdown. That was probably more an issue with the circuitry in the computer room than the UPS though. At least it confirmed that the signalling worked. Pam Phillips Sr. AS/400 Systems Analyst Abbott Laboratories MediSense Products 4A Crosby Drive Bedford MA 01730 pam@xxxxxxxxxxxxx 781-276-6144 Fax: 781-687-5246
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.