Over WAN, the timers on the controller description may not be allowing enough time for device to go active. Try increasing the timer value DEVWAITTMR to like 60 seconds. Have to Vary off/on after change. Is this a new setup or a recent change? jim ----- Original Message ----- From: "Karthikeyan S" <firstname.lastname@example.org> To: <email@example.com> Sent: Tuesday, May 28, 2002 10:42 PM Subject: printer not varying on -- [ Picked text/plain from multipart/alternative ] We have a AS/400 530-2153. They are connected to various branches through Ethernet and SDLC line. The problem now with the branch printers. They seem to be just in Vary On Pending status. We can't seem to get them to Active status. These are 5224 IBM printers. These printers are connecting through NT server. The NT server is connected through a router and this router is connected through another router. This router is connected to the AS/400. We are using Microsoft SNA Server 5250 emulation. These printers are connected to virtual controllers and virtual printer devices. Only the controllers are on Active status while the devices are in Vary On Pending. So, the writers are not starting. For your information, we are running Version 3 Release 7. Solutions please. TIA. --------------------------------- Do You Yahoo!? Yahoo! - Official partner of 2002 FIFA World Cup _______________________________________________ This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list To post a message email: MIDRANGE-L@midrange.com To subscribe, unsubscribe, or change list options, visit: http://lists.midrange.com/cgi-bin/listinfo/midrange-l or email: MIDRANGE-Lfirstname.lastname@example.org Before posting, please take a moment to review the archives at http://archive.midrange.com/midrange-l.
This mailing list archive is Copyright 1997-2013 by MIDRANGE dot COM and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available here. If you have questions about this, please contact