I have only 1 ASP correct....good question...I should have stated that.
1 ASP....6 disk units....all DPY/Active.
Also...I have tried 3 different tapes...and cleaned the drive between each
use.
It's a 7208 tape drive Model 342 (8mm drive).
Deleting the device/manually recreating wasn't hard...but unfortunately that
didn't work either.
-----Original Message-----
From: Andy Nolen-Parkhouse [mailto:aparkhouse@mediaone.net]
Sent: Tuesday, January 22, 2002 11:00 AM
To: midrange-l@midrange.com
Subject: RE: V5R1 savsys problem.
A thought from when I've been in a similar situation (more than once).
List out the TAP01 device description (dspdevd tap01 output(*print).
Then vary off and delete. Manually recreate the device. There is no
need to IPL. Vary back on and try the command. There is a chance that
the autocreate at IPL description is being created with some kind of
error.
Also (in case you haven't), clean the drive and use a new tape.
Not much to go on. I am assuming (since you don't mention it) that you
have no independent ASPs on your system.
Regards,
Andy Nolen-Parkhouse
>
> Trying to do a SAVSYS (V5R1M0) and get the following error(s) in my
> joblog.
_______________________________________________
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@midrange.com
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/cgi-bin/listinfo/midrange-l
or email: MIDRANGE-L-request@midrange.com
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.
