Re: Printing problem on V4R5

[theresa.luebeck@xxxxxxxxxxx]

Since we went to V4R5, we also have had some similar IP printing issues.  I
found that the external jet direct 'idle-timeout' setting was set too low.
Try telneting into the jet direct from the AS/400 system where you have the
device or out queue defined.  Enter '/' to view the settings.  Rochester
recommended to me to set the idle-timeout to 3600 seconds.  We did and our
problems cleared up.  To change the setting type 'idle-timeout: 3600'.
Enter '/' to review the settings and to save type 'quit' to save and exit.
If you don't type 'quit' the changes won't be saved.
Best of luck,
Theresa Luebeck

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---