RE: AS/400 with Ethernet NIC, frame relay, etc.

Chuck:
When you create the lind for the ethernet lin, use link speed *MAX, I think
the default is 10M (this assumes you will be installing a 10/100 card and
your hub/switch is 100M).
CJG


Carl J. Galgano
EDI Consulting Services, Inc.
540 Powder Springs Street, Suite C19
Marietta, GA  30064
(770) 422-2995 - voice
(419) 730-8212 - fax
mailto:cgalgano@ediconsulting.com
http://www.ediconsulting.com
AS400 EDI, Networking, E-Commerce and Communications Consulting and
Implementation

-----Original Message-----
From: owner-midrange-l@midrange.com
[mailto:owner-midrange-l@midrange.com]On Behalf Of Chuck Lewis
Sent: Saturday, March 11, 2000 6:59 PM
To: Midrange Mailing List
Subject: AS/400 with Ethernet NIC, frame relay, etc.
Importance: High


Hi Folks,

I come from a Token Ring background. Last job we had a 530 with 2 T/R
NIC's. Here I just installed an Ethernet NIC last week in anticipation
of our move to Frame Relay from Leased Lines.

Are there any parameters of particular importance to CHANGE from the
defaults for an Ethernet line? I know we found some when we did the
Token Ring setup and others after the fact.

Ditto for changing the controllers from the leased lines to Frame Relay
(we are running the Perle 494E's) ?

TIA !

Chuck

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator:
david@midrange.com
+---

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---