Re: Y2K Group PTF

Hi,

Thanks for the replies, please excuse my general uneasyness with the
PTF process. But because it 'messes' with system internals I'd rather
not take guesses so at to get it right the first time. 

>The text for the Y2K Group PTF 99200 is being updated to include:
>"Both media volumes included in this order should be treated as separate
>  single PTF orders. There is not a prompt to load the second volume.
>  Refer to the PTF Installation Instructions included in this order."

I hope they won't forget to actually include with the CD's the
instructions they refer to. It would be a very welcome move.

> You should go through the install procedure with the second CD.  If you
> have also re-installed the first CD then there should be no harm done.

I'll be doing the install off the second CD again this week-end.
 
> Hopefully the above changes, along with some new web interfaces to the
> Y2K PTF information that went in last week, will help with users
> preparing for Y2K.

I did search the knowledgebase, cover letters, etc. where I found an
item which is a general recomendation to use go ptf 8 to install ptf's
supplied on media by IBM. Nothing specific on installing group ptf's
including the y2k one yet. 
I'll keep looking though.

Thanks very much for helping me out here.
Best regards,
Matthias

---------------------------------------------------------------------
Matthias Oertli   <oertlim@s054.aone.net.au>
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---