RE: Prompting of CL commands -- CODE400-L

× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.

Buck, that is not the Autoconnect server - you had to start one manually ;-)

Actually, I prefer the STRCODE prompting - it is much faster. Oh - but pretty is better, right? <g>

Vern

At 03:02 PM 3/26/2003 -0500, you wrote:

>My frustration stems from trying to prompt CL commands.
>When I press F4 I receive the message 'You must have
>a STRCODE server running in an interactive job to
>run the command.  Please start a STRCODE server and try
>again.'  I have looked at the help text and gone
>through the Partner400 Quick Start Guide without
>any success.  How can I start the server so I can
>prompt CL commands?  I would prefer to use the
>AutoConnect server.

To be honest, I don't think I have ever prompted a CL command in Code...
odd.  Anyway, the error message is a very good one, because it tells you
exactly what to do.  Go to a terminal emulation session and do STRCODE.

I just tried it.  I typed in DSPPFM and pressed F4... Got the message.  Went
to green screen, typed STRCODE, enter.  Green screen is busy with the server
now.  Back to Code, press F4.  The green screen pops up the prompt, which I
fill in, and after I press enter, the Code editor is populated.  Auto server
works fine.
  --buck

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.