Re: VARPG - DLL error on build of VARPG project

Your app is still running.  Do a CRTL+ALT+DEL and look for your
app in the list and end it.  
The real problem is that you are not ending your app correctly.
Are you turning *INLR on someplace when exiting the app?
Or is it just dying because of some runtime error?  
-- 
------------------------------------------------------
Scott P. Johnson
Microcomputer Development Specialist
IBM Certified Specialist - AS/400 RPG Programmer
Highsmith Inc.
W5527 Hwy 106, PO BOX 800
Fort Atkinson, WI 53538-0800
TEL:  920-563-9571                FAX:  920-563-7395
sjohnson@highsmith.com
www.highsmith.com
------------------------------------------------------
"Duffy, Eric" wrote:
> 
> After an initial build and run of a project, all following builds receive an
> error message referring to the project's DLL file.  The message says that
> the DLL is locked and can not be updated. I was not running the project at
> the time of the second build.  I've even shut down VA and CODE/400 but
> rebooting the PC was the only thing that unlocked the DLL.  This happens
> every time I run, modify and rebuild the project.  Any suggestions on how to
> correct the error?  I've attached the error message below.
> 
> Thanks,
> 
> Eric Duffy
> Duffy@ae.com <mailto:Duffy@ae.com>
+---
| This is the CODE/400 Mailing List!
| To submit a new message, send your mail to CODE400-L@midrange.com.
| To subscribe to this list send email to CODE400-L-SUB@midrange.com.
| To unsubscribe from this list send email to CODE400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: larry@paque.net
+---