Re: RDI 9.6 editing RPG/400

With my source open for edit, i held down the control key, then single
clicked a local procedure name. . . tried subroutine name too. . .

John





From: "Joe Pluta" <joepluta@xxxxxxxxxxxxxxxxx>
To: wdsci-l@xxxxxxxxxxxxxxxxxx
Date: 03/26/2020 01:26 PM
Subject: Re: [WDSCI-L] RDI 9.6 editing RPG/400
Sent by: "WDSCI-L" <wdsci-l-bounces@xxxxxxxxxxxxxxxxxx>



Which thing doesn't work? The hyperlink? I thought that had been
around for a long time, but it's been a while since I was on 9.6.0.0.

Any reason you haven't upgraded? Because the RDi folks do tons of
enhancements each release.


On 3/26/2020 10:36 AM, John B. via WDSCI-L wrote:

Hi Joe -- Did not know this, so i tried it . . . This must not be in
version 9.6.0.0.?

John

I use hyperlinks. One of my favorite features. Hold down the control
key and click on the name of something being used (e.g., in an EXSR or

a

procedure call) and RDi jumps you to the definition. Even cooler,
Alt-Left brings you back to where you were. And this works for
variables, too.

This is next-level stuff for me. :)

----------------------------------------------------------------------
The information in this email is confidential and may be legally

privileged.

It is intended solely for the addressee. Access to this email by anyone

else is

unauthorized. If you are not the intended recipient, any disclosure,

copying,

distribution or any action taken or omitted to be taken in reliance on

it, is

prohibited and may be unlawful.