Re: Debug

When I took the conditional expression off the breakpoint, the program was stopping at the breakpoint, but the record I need to debug is thousands of cycles. I re-added the breakpoint conditional expression but instead of using the database field I used the input parameter for the sub-procedure because I noticed that the database fields were not visible in the Variables tab but the input parm was. That worked fine.

Terry Hertel
Programmer/Analyst
Peerless Industrial Group
A Kito Group Company




-----Original Message-----
From: Terry Hertel
Sent: Tuesday, November 27, 2018 5:20 PM
To: 'wdsci-l@xxxxxxxxxxxx' <wdsci-l@xxxxxxxxxxxx>
Subject: RE: Debug

Thanks Jon. I figured out how to set a conditional breakpoint but it doesn't stop at the line. When I run the program (in batch) the debug display stops at the first line of the program, which is a comment. The I click on the green Resume button. Should I be clicking on something else? My conditional expression is pretty simple: ememply = '1784'.

Terry Hertel
Programmer/Analyst
Peerless Industrial Group
A Kito Group Company




-----Original Message-----
From: Terry Hertel
Sent: Tuesday, November 27, 2018 5:02 PM
To: 'wdsci-l@xxxxxxxxxxxx' <wdsci-l@xxxxxxxxxxxx>
Subject: Debug

I rarely use the RDi debugger so I am pretty rusty at it. I am trying to use it for a batch job. I have my service entry point set and working, but how do I set it up to break at a specific line when a database field reaches a certain value? There's got to be a better way than stepping through every read until I hit the one I am interested in. Seems like I have done it before but it must have been in another lifetime.