Re: RDi 9 (9.1.1 and 9.5) debug question

[Vernon Hamberg <vhamberg@xxxxxxxxxxxxxxx>]

Peter

I suspect that, because the reference to the source is stored in the 
object, that it will always revert to that reference. Any setting you 
use in RDi will not become a part of the object - it's pretty cool that 
you don't need the source on the running machine now, at any rate.

Just my thoughts around midnight!

Vern

On 9/30/2015 11:27 PM, Colpaert, Peter wrote:
> Dear group,
>
> We have a configuration with our development and test/production environments running on separate partitions.
>
> For RDi these are different systems, which kind of causes an annoyance when debugging with SEP's.
>
> Sources are stored on the DEV system only, so when I debug a program on the test/prd system, I get the "source not found" message.
>
> I then "Edit Source Lookup Path..." and point it to the source on our DEV partition.
>
> However, I need to do this again and again every time I run a debug.
>
> Isn't there some way to make the source lookup path "stick"?  I vaguely remember this question having been asked some releases back.
>
> Thanks,
>
> Met vriendelijke groeten / Best regards,
>
> Peter Colpaert
> Software Engineer - PLM Development Team Lead
> R&D IT
>
> Philips Consumer Luminaires
> Industrieterrein Satenrozen 11, 2550 Kontich, Belgium
> Tel: (+32) 3/459 13 17
> Email: Peter.Colpaert@xxxxxxxxxxx<mailto:Peter.Colpaert@xxxxxxxxxxx>
>
> Working from home on Wednesdays
>
> [Shield_email]<http://www.philips.com/>
>
>
> ________________________________
> The information contained in this message may be confidential and legally protected under applicable law. The message is intended solely for the addressee(s). If you are not the intended recipient, you are hereby notified that any use, forwarding, dissemination, or reproduction of this message is strictly prohibited and may be unlawful. If you are not the intended recipient, please contact the sender by return e-mail and destroy all copies of the original message.