Shucks, I guess something got hosed up...
I restarted RDi 9.0.1, and now I can compile my code with no problems!
I guess it was just a "FLUKE"...
PS. I don't remember encountering this error before. But I was doing a lot of hoping around, and debugging and work on various members...
-Ken Killian-
-----Original Message-----
From: wdsci-l-bounces@xxxxxxxxxxxx [mailto:wdsci-l-bounces@xxxxxxxxxxxx] On Behalf Of Ken Killian
Sent: Thursday, March 20, 2014 3:53 PM
To: wdsci-l@xxxxxxxxxxxx
Subject: [WDSCI-L] RDi 9.0.1 --> Compiler Failure..
Hi,
I am using RDI 9.0.1, and all of sudden I cannot seem to compile...
<strange>
My Command Log View shows this:
CRTBNDRPG PGM(KKILLIAN/MCXAERRW) SRCFILE(KKILLIAN/QRPGLESRC) SRCMBR(MCXAERRW) OPTION(*EVENTF) DBGVIEW(*ALL) REPLACE(*YES) Pointer not set for location referenced.
Cause . . . . . : A pointer was used, either directly or as a basing pointer, that has not been set to an address.
Compilation failed. Program MCXAERRW not created in library KKILLIAN.
Cause . . . . . : Compilation failure normally occurs when the severity of issued messages exceeds the value specified for the GENLVL parameter on the CRTBNDRPG command. See the compiler listing or the job log for error messages. Recovery . . . : Correct the errors or change the value specified for the GENLVL parameter. Compile again.
Application error. MCH3601 unmonitored by QQDAPROC at statement *N, instruction X'0199'.
Cause . . . . . : The application ended abnormally because an exception occurred and was not handled. The name of the program to which the unhandled exception is sent is QQDAPROC . The program was stopped at the high-level language statement number(s) *N at the time the message was sent. If more than one statement number is shown, the program is an optimized ILE program. Optimization does not allow a single statement number to be determined. If *N is shown as a value, it means the real value was not available. Recovery . . . : See the low level messages previously listed to locate the cause of the exception. Correct any errors, and then try the request again.
I can compile on Green-Screen however...
Should I open PMR on this?
PS. I close the member, and then tried to reopen, and still no success...
-Ken Killian-
--
This is the Rational Developer for IBM i / Websphere Development Studio Client for System i & iSeries (WDSCI-L) mailing list To post a message email: WDSCI-L@xxxxxxxxxxxx To subscribe, unsubscribe, or change list options,
visit:
http://lists.midrange.com/mailman/listinfo/wdsci-l
or email: WDSCI-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives at
http://archive.midrange.com/wdsci-l.
midrange.com
