Re: RDi

1) Yup, there is an APAR open for that. A work-around is to click on the
button then back on the source and I think the icons should light up again
SE56558 - RDI 9.0.0.1 VERIFY BUTTON DISABLED AFTER SWITCHING FROM
ANOTHER SOURCE MEMBER TO AN RPGLE SOURCE MEMBER

2) and there is an APAR open for that too, the work-around for it is to
use the button rather than pushing Enter but you have figured that out
already ;)
SE55983: RDI 9.0.0 FIND IN LPEX ONLY FINDS EVERY OTHER MATCH WHEN USING
ENTER

Mike



Mike Hockings, M.Eng., P.Eng.
IBM Rational Developer for System z and Power Systems Software Technical
Support
IBM Canada Ltd. Laboratory
hockings@xxxxxxxxxx
voice 1-905-413-3199 T/L 313-3199 ITN 23133199




From: "Englander, Douglas /c" <Douglas_Englander@xxxxxxxxxxxxx>
To: "wdsci-l@xxxxxxxxxxxx" <wdsci-l@xxxxxxxxxxxx>,
Date: 2013-10-03 12:18
Subject: [WDSCI-L] RDi
Sent by: wdsci-l-bounces@xxxxxxxxxxxx




On Release 9.0 without service packs, has anyone ever noticed the
following:


1. Occasionally, when using the LPEX Editor in Edit mode (as opposed to
Browse mode), the Verify and Compile pushbuttons "magically" become
disabled? I always have to save my source, close it, and then open it
again in order for the Verify and Compile pushbuttons to be enabled again.


2. Always, when using the LPEX Editor in Edit mode, has anyone noticed
that when you perform a FIND, that if you press the PC Enter key to find
the next occurrence, that it does not consistently find the next
occurrence? It only consistently finds the next occurrence when you click
on NEXT instead of pressing the PC enter key.

If anyone has had these issues resolved, can you let me know what the
resolution process was?

Thank you,

Doug