Hi, Ken,
The green-screen debug using STRRJESSN should work just fine with RDP
8.5.1. Do you have the latest debugger PTF applied? You can check this
with the Verify Connection...
Mike
Mike Hockings, M.Eng., P.Eng.
IBM Rational Developer for System z and Power Systems Software Technical
Support
IBM Canada Ltd. Laboratory
hockings@xxxxxxxxxx
voice 1-905-413-3199 T/L 313-3199 ITN 23133199
From: Ken Killian <kkillian@xxxxxxxxxxxx>
To: "Rational Developer for IBM i / Websphere Development Studio
Client for System i & iSeries" <wdsci-l@xxxxxxxxxxxx>,
Date: 2013-02-20 08:13
Subject: Re: [WDSCI-L] debug no longer working
Sent by: wdsci-l-bounces@xxxxxxxxxxxx
Too bad the regular debug a session does NOT work on RDP 8.5, like it did
on RDP 8.0
I do like the SEP, but sometimes the debug a green screen session, like it
used to work...
:(
-Ken Killian-
(423) 510-3129
-----Original Message-----
From: wdsci-l-bounces@xxxxxxxxxxxx [mailto:wdsci-l-bounces@xxxxxxxxxxxx]
On Behalf Of Buck Calabro
Sent: Tuesday, February 19, 2013 5:43 PM
To: wdsci-l@xxxxxxxxxxxx
Subject: Re: [WDSCI-L] debug no longer working
On 2/19/2013 5:14 PM, dale janus wrote:
Now that I found remote systems explorer, I have lost debug.
-snip-
Now when I run the job, it completes and RDI never starts debugging.
What am I missing? I did not change the libraries and the service
entry point tab shows the correct program in the correct library with
enabled yes.
I have started and stopped RDI a few times.
I myself never seem to have a problem with debug but my colleagues
occasionally report this very issue. The advice I give them is to end
their green screen sessions in case there's an activation group issue.
This tends to clear up almost all of the issues they have.
On the rare occasion that hasn't helped, I ENDDBGSVR and STRDBGSVR, which
always does the trick.
I never do anything on the SEP menu except for Set, Remove and Refresh.
I do a Refresh after every compile, and Remove when I'm done.
--buck
--
This is the Rational Developer for IBM i / Websphere Development Studio
Client for System i & iSeries (WDSCI-L) mailing list To post a message
email: WDSCI-L@xxxxxxxxxxxx To subscribe, unsubscribe, or change list
options,
visit:
http://lists.midrange.com/mailman/listinfo/wdsci-l
or email: WDSCI-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives at
http://archive.midrange.com/wdsci-l.
midrange.com
