Re: When out lining in WDSC 7.0 what if the program isto big, does that matter?

In the for what it is worth category...

WDSC 7.0 can outline and verify very large source file (the largest I've
done is 25K+ lines ... I am not saying how long it took ... but I would
do it before going to lunch).

One source member in our system forced the adoption of RDi because it
was too big for SEU to open (really -- DFU/DBU was used to edit that
source member). And that is before the copies and such. WDSCi could
open, edit, outline and verify that!

[ This was not one of my programs <grin> ]

Patches released within the last year to 18 months correct "leaks" in
the cache. The symptom is WDSC 7.0 locks up / was very sluggish until
the cache is cleared.

RDi handles these very large source members much, much better than
WDSCi. I ran the heavy version of WDSC until RDi was adopted early this
year.

I think the difference between lite and heavy is in the installation
process. I tried both versions and didn't see any performance
improvement.



-----Original Message-----
From: wdsci-l-bounces@xxxxxxxxxxxx [mailto:wdsci-l-bounces@xxxxxxxxxxxx]
On Behalf Of Ryberg, James
Sent: Tuesday, October 06, 2009 3:51 PM
To: 'Websphere Development Studio Client for iSeries'
Subject: Re: [WDSCI-L] When out lining in WDSC 7.0 what if the program
isto big, does that matter?

Thanks, so size is not the issue. What about running in lite mode
instead of a higher mode and how do you change it in WDSC 7.0?

James L. Ryberg, Sr.
Associated Bank Corp.
Programmer Analyst
Mail Stop : 7055
Work : (920) 405-2522
Fax : (920) 405-2533
Email : James.Ryberg@xxxxxxxxxxxxxxxxxxx


-----Original Message-----
From: wdsci-l-bounces@xxxxxxxxxxxx [mailto:wdsci-l-bounces@xxxxxxxxxxxx]
On Behalf Of Bob P. Roche
Sent: Tuesday, October 06, 2009 3:45 PM
To: Websphere Development Studio Client for iSeries
Subject: Re: [WDSCI-L] When out lining in WDSC 7.0 what if the program
is to big, does that matter?

I have an old order entry program that shows 8615 lines. It takes a
while
to outline, but it works.



From:
Jon Paris <jon.paris@xxxxxxxxxxxxxx>
To:
wdsci-l@xxxxxxxxxxxx
Date:
10/06/2009 03:41 PM
Subject:
Re: [WDSCI-L] When out lining in WDSC 7.0 what if the program is to big,

does that matter?
Sent by:
<wdsci-l-bounces@xxxxxxxxxxxx>



Too big for what?

I'm not aware of any size limit - the outline data is built by the
same logic as used in the Verifier.

There must be some limit but I suspect if your program is that big you
have other problems!


Jon Paris

www.Partner400.com
www.SystemiDeveloper.com



On 6-Oct-09, at 3:57 PM, wdsci-l-request@xxxxxxxxxxxx wrote:

When out lining in WDSC 7.0 what if the program is
to big, does that matter?