×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
Perhaps a question to ask is...
What causes the member lock to occur, and how can it be prevented? Doing a
disconnect can be a major pain.
Anyone know about the cause?
Have a good day.
Blake Moorcroft
Developer - Corporate
Russell A. Farrow Limited
1980 Ambassador Drive, PO Box 333, Windsor, Ontario N9C 3R4
Bus: 519-966-3003 ext. 566, Fax: 519-966-9870
blake.moorcroft@xxxxxxxxxx
Justin Taylor
<JUSTIN@lorencook
.com> To
Sent by: "wdsci-l@xxxxxxxxxxxx"
wdsci-l-bounces@m <wdsci-l@xxxxxxxxxxxx>
idrange.com cc
Subject
05/07/2008 02:56 [WDSCI-L] Left-over member locks
PM
Please respond to
Websphere
Development
Studio Client for
iSeries
<wdsci-l@midrange
.com>
Occasionally, WDSc 7 will retain a member lock even after the source member
is closed. Is there any way, other than ending WDSc, to release the lock?
--
This is the Websphere Development Studio Client for iSeries (WDSCI-L)
mailing list
To post a message email: WDSCI-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit:
http://lists.midrange.com/mailman/listinfo/wdsci-l
or email: WDSCI-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at
http://archive.midrange.com/wdsci-l.
midrange.com
