Re: Compling( Binding two modules together)

I came across this problem with a Cobol module and it was because the
PROGRAM-ID specification had another module name (because I copied it
from another source). So if your module is Cobol then the source should
have PROGRAM-ID. PNCOPYM.

Hope this helps.

Best regards,

Mark Austin
IT Consultant
Universal Music Publishing International
Email: mark.austin@xxxxxxxxxx
Tel: +44 (0) 20 8742 5520
Fax: +44 (0) 20 8742 5699

Universal Music Publishing International Limited
Registered in England. Number 02050403
Registered Office: 347-353 Chiswick High Road, London W4 4HS
-----Original Message-----
From: wdsci-l-bounces@xxxxxxxxxxxx [mailto:wdsci-l-bounces@xxxxxxxxxxxx]
On Behalf Of Jeremy_Rowden@xxxxxxxxxx
Sent: 31 October 2007 21:20
To: wdsci-l@xxxxxxxxxxxx
Subject: [WDSCI-L] Compling( Binding two modules together)

Hello everyone,

I created a module called PNCOPYM and
when I used the Crtpgm command to bind it with a CL
module I created I keep getting the following message.

Definition not found for symbol 'PNCOPYM'.
Cause . . . . . : No definition was found for reference PNCOPYM in
*MODULE
object DACOPYCL in library ULRMODS. The definition either does not
exist
or
is not of the same data or procedure type as the reference.
Recovery . . . : Try the Create Program (CRTPGM) command again,
supplying
an object that contains a definition for symbol PNCOPYM.


Has anyone run into this before? If so any tips would be greatly
appreciated




















Jeremy R. Rowden
Nippon Express USA, Inc.
Information Systems Division