Re: V7 SEP Debugger question

Gerald,

Could you please check if the following preference is checked:

Window -> Preference -> Run/Debug -> Compiled Debug -> Always use Debug
Editor while debugging.

If yes, it means the debugger always use something called Debug Editor to
display source. This may not be the one you want.
If you want to use the iSeries system editor to display source, please
uncheck this checkbox.

Thanks,

Xuan Chen, Problem Determination Tools for iSeries
(905) 413-3769 T/L 969-3769
xuanchen@xxxxxxxxxx





GKern@xxxxxxxxxxxxxxxx
Sent by: wdsci-l-bounces@xxxxxxxxxxxx
05/14/2007 09:32 AM
Please respond to
Websphere Development Studio Client for iSeries <wdsci-l@xxxxxxxxxxxx>


To
wdsci-l@xxxxxxxxxxxx
cc

Subject
[WDSCI-L] V7 SEP Debugger question






Not necessarily SEP related but....

While debugging and doing the step through, when the code enters a called
module, my view changes to show only the source member currently being
debugged.

When I was using V6, I had all the tabs available for all the source
members touched by stepping through each source member within the call
stack.

Where in the preferences can I set this behavior back to show all of the
source members encountered during the debug session, so that I can quickly

click on any of the tabs of each member (being debugged) in the stack?

Thanks!

Regards, Jerry

Gerald Kern - MIS Project Leader
Lotus Notes/Domino Administrator
IBM Certified RPG IV Developer
The Toledo Clinic, Inc.
4235 Secor Road
Toledo, OH 43623-4299
Phone 419-479-5535
gkern@xxxxxxxxxxxxxxxx


This e-mail message, including any attachments, is for the sole use of the

intended recipient(s) and may contain confidential and privileged
information. Any unauthorized use, disclosure or distribution is
prohibited. If you are not the intended recipient, please inform the
sender by reply e-mail and destroy this and all copies of this message.