Re: RPG source in RSE not being saved to iSeries

I just found that in RSE by right clicking on iSeries commands and 
selecting servers, that if I shut all the servers down, and restart RSE, 
it prompts me to, from the green screen, to STRHOSTSVR *ALL and STRTCPSVR 
*DDM.  After doing so then RSE comes up.

I was then able to enter my initials in the prefix area and did a save and 
it actutally got saved to the iSeries. So I suspect it has something to do 
with recycling these servers (but which one?).

And yes Aaron - I noticed that after doing the above that the ctrl-s did 
take 'longer' than it was during my other attempts at diagnosing this bug.

However recycling the servers probably isn't a good solution as its not 
practical on production boxes. Luckily I'm on a test box and the only one 
who uses WDSCi (out of seven programmers).

Regards, Jerry

Gerald Kern - MIS Project Leader
Lotus Notes/Domino Administrator
IBM Certified RPG IV Developer
The Toledo Clinic, Inc.
4235 Secor Road
Toledo, OH 43623-4299
Phone 419-479-5535
gkern@xxxxxxxxxxxxxxxx


This e-mail message, including any attachments, is for the sole use of the 
intended recipient(s) and may contain confidential and privileged 
information. Any unauthorized use, disclosure or distribution is 
prohibited. If you are not the intended recipient, please inform the 
sender by reply e-mail and destroy this and all copies of this message.