Re: 'Compile in batch' does nothing

Hey Michael,

Hmmm, I vaguely recall seeing something like this before.
1. Do you have any preferences set for the SBMJOB additional parameters in
the Command Execution preference page?
2. Would you mind posting the whole command that appears in the Command
Log?

thanks,

Violaine Batthish
WebSphere Development Studio Client, IBM Toronto Lab



wdsci-l-bounces@xxxxxxxxxxxx wrote on 12/12/2006 10:59:06 AM:

Violaine,

So far I've tried the button on the toolbar, right-clicking from the RSE
tree or iSeries Table View, Ctrl+Shift+C, and with and without prompting
from the Compile option on the menu bar.  They all produce the same
results.  The iSeries Commands Log shows the following:

'SBMJOB CMD(.....'

then on the line immediately following, it adds:

'Command has completed'

If I submit a compile on my PC, I receive the 'SBMJOB ....' then mine has

the message (or a similar one):

'Job 827151/xxxxxxx/JDAH submitted to job queue DEVELOP1 in library

QGPL.'

Thanks,
Michael Quigley
AS/400 Programming Section
The Way International
www.TheWay.org

wdsci-l-bounces@xxxxxxxxxxxx wrote on 12/11/2006 10:08:09 PM:

date: Mon, 11 Dec 2006 14:19:57 -0500
from: Violaine Batthish <batthish@xxxxxxxxxx>
subject: Re: [WDSCI-L] 'Compile in batch' does nothing

Hey Michael,

1. How are you compiling (from RSE, Ctrl+Shift+C in RS LPEX, toolbar

button

etc)

2. Do you see any messages in the Command Log view?

thanks,

Violaine Batthish
WebSphere Development Studio Client, IBM Toronto Lab



wdsci-l-bounces@xxxxxxxxxxxx wrote on 12/08/2006 09:20:10 AM:

I have checked the archives, but haven't found anything specific

help.

I just installed WDSC for another developer and applied all the

updates.

Everyone else here has 'Compile in batch' checked in the preferences

and

things work just fine.  However if I check it on his setup, nothing
happens: the job doesn't show up in the 'iSeries Job Status' view

(the

option is checked to add batch compiles to it), no job appears on the
AS/400, no error messages appear anywhere that I can find.  I could
uncheck the option, but some of the compiles take a while and it ties

up

the workbench--the progress bar keeps going until retrieves the event
file.

Anyone have any suggestions on what else to check?  If not, I'll put

a

call into IBM.