Re: Interactive Debugging

You could do that using Service Entry Point.

Right click on the program/service program in RSE, and choose Debug 
(Service Entry) -> Set Service Entry Point.
After the service entry point is set, it should be in the Service Entry 
Point view.  Right click on it in the Service entry point view, and choose 
Modify.
You could modify the user id of the service entry point to that particular 
user.

When that user runs that program/service program, a debug session will 
come up with the program under debug.

But there are some authorities you  need to have in order to do it.  I 
believe you need to have *SERVICE authority, and need to have *USE 
authority to that user's profile + the necessary authority for debugging.

Thanks,

Xuan Chen,  Problem Determination Tools for iSeries
(905) 413-3769 T/L 969-3769
xuanchen@xxxxxxxxxx





"Bill Barnes" <bbarnes@xxxxxxxxxxxxx> 
Sent by: wdsci-l-bounces@xxxxxxxxxxxx
11/28/2006 08:56 AM
Please respond to
Websphere Development Studio Client for iSeries <wdsci-l@xxxxxxxxxxxx>


To
<wdsci-l@xxxxxxxxxxxx>
cc

Subject
[WDSCI-L] Interactive Debugging






I am not sure about this, but I heard somewhere that it was possible to
debug an interactive program by userid.  What I thought was that it
could be set up in advance and as soon as a particular user started
using the program it would come up in debug mode.  Am I correct or was I
dreaming?

 

Thanks

Bill Barnes

Sr Analyst/Programmer

The Pantry, Inc

919-774-6700

ext 5211