Re: Installing CODE400 and CODE DESIGN Tool

No you don't need to start with the first disk again.  Just input the disk 
for the CODE400 and it should start.  Double check though that it is the 
6th disk, I'm guessing at that...  not too sure how good the ol' noggin is 
today... I haven't had much success with anything today.  Fuzzy to say the 
least.

Ron Power
Programmer
Information Services
City Of St. John's, NL
P.O. Box 908
St. John's, NL
A1C 5M2
709-576-8132
rpower@xxxxxxxxxx
http://www.stjohns.ca/
___________________________________________________________________________
Success is going from failure to failure without a loss of enthusiasm. - 
Sir Winston Churchill




"Jon Sinner" <JSinner@xxxxxxxx> 
Sent by: wdsci-l-bounces@xxxxxxxxxxxx
2006/01/06 12:58 PM
Please respond to
Websphere Development Studio Client for iSeries <wdsci-l@xxxxxxxxxxxx>


To
"Websphere Development Studio Client for iSeries" <wdsci-l@xxxxxxxxxxxx>
cc

Subject
Re: [WDSCI-L] Installing CODE400 and CODE DESIGN Tool






So do I just start with the first disk and will it ask me for the
correct disk or should I just put in the 6th disk? 
Do I then have to reinstall the updates?


-----Original Message-----
From: wdsci-l-bounces@xxxxxxxxxxxx [mailto:wdsci-l-bounces@xxxxxxxxxxxx]
On Behalf Of RPower@xxxxxxxxxx
Sent: Friday, January 06, 2006 9:39 AM
To: Websphere Development Studio Client for iSeries
Subject: Re: [WDSCI-L] Installing CODE400 and CODE DESIGN Tool


It's on the 6th disk I think, I don't have them in front of me, but they

are the extras that you didn't use in the first install.

Ron Power
Programmer
Information Services
City Of St. John's, NL
P.O. Box 908
St. John's, NL
A1C 5M2
709-576-8132
rpower@xxxxxxxxxx
http://www.stjohns.ca/
________________________________________________________________________
___
Success is going from failure to failure without a loss of enthusiasm. -

Sir Winston Churchill




"Jon Sinner" <JSinner@xxxxxxxx> 
Sent by: wdsci-l-bounces@xxxxxxxxxxxx
2006/01/06 12:00 PM
Please respond to
Websphere Development Studio Client for iSeries <wdsci-l@xxxxxxxxxxxx>


To
<WDSCI-L@xxxxxxxxxxxx>
cc

Subject
[WDSCI-L] Installing CODE400 and CODE DESIGN Tool






Hi,

I recently installed WDSC V6.0
I then installed the current update.

I would now like to install CODE400 and the Design Tool for designing
DSPF's.

Can anyone give me some advise on the best way to accomplish this
install.

TIA

Jon